I think I've really screwed up the elecrics this time...
 

To cut the whole story short I've buggered the datatool alarm on my SK4 while trying to extend the indicators. I cut the wires and soldered an extension onto them. As soon as I tried to switch the ignition the alarm went off and will not stop and the bike will not start :shock: Any ideas on what to do?
The alarm is a datatool system 3.

check the alarm fuse, should possably be a sepeate wire next to the bikes fuse box.

checked that, I've also disconnected the battery but the alarm just keeps going on.

Sounds to me like your alarm isnt disarming.

Have you got a spare keyfob ? if so try and disarm the alarm with that

If not find the alarm manual and try and resynch your keyfob with the alarm.

Failing that you might have blown a fuse

Cant really offer much help, I've had problems with my data tool before and the re-sych process sorted them out

HTH

have you tried dissarming with the security code via the ignition?

I do beleave that there is also an internal fuse inside the datatool unit, but you will need security torx bits to get it open.

Problem sorted :D It was the 10A engine fuse.
Did go through a very tense 50 minutes though... Cheers for the advice