cutting off exhaust
 

could any1 enlighten me on this. n how do i do it?

much love
jay

Re: cutting off exhaust
 

mark on it where you need to cut and saw it off, we used a hack saw

Re: cutting off exhaust
 

ooo. is there anywere special its needs to be cut off? and how does it all go back together again? :S

Re: cutting off exhaust
 

yes, the instructions from our fuel can said cut it 50mm after the weld (i think).
if you want to put the original can back on you'll need a link pipe.

prolly worth a search if you have any more questions about this.

Re: cutting off exhaust
 

ok cheers though m8y

Re: cutting off exhaust
 

Did you not get any instructions with your can.

Distance will vary depending on the manufacturer, its normally between 40 - 50mm, measured from the weld

See below, marked with the red arrow.

http://i42.photobucket.com/albums/e3...l/DSC_0062.jpg

You want a good quality blade in a haxsaw or an angle grinder. Cover up your swing arm with something to protect it from over enthusiastic cutting / sawing, Also take care you dont cut your heel plates.

Oh and measure twice, cut once.