![]() |
Can't use my SV in the wet.
Hello,
I have an sv650 k1, when i take the bike out in the wet the spray form the front wheel gets into the front spark plug, and the bike then runs like a 50cc, i have tried new spark plug leeds, fender extender, wd40, so now im out of ideas, CAN SOMEONE PLEASE HELP ME ON THIS ONE????? |
Re: can use my sv in the wet, HELP
If a fender extender hasn't sorted it, you'll need to dry it out again, then stick the plug back in & cover in silicon grease.
|
Re: can use my sv in the wet, HELP
Could be a problem elsewhere. Check the connections to the coils. Maybe water is getting in there. Crimp em up tight.
|
Re: can use my sv in the wet, HELP
You need to make sure the drain hole on the side of the engine is cleaned out and free of dirt. This then stops the plug hole from filling with water.
|
Re: can use my sv in the wet, HELP
If it was like mine the front lead and plug were fuchsaid, get a new plug, plug holder and a length of HT lead and change the lot. it wont tell which bit was wrong but at least it will work
h |
Re: can use my sv in the wet, HELP
Quote:
I have tried that and it still gets wet, ant other ideas please ???? |
Re: can use my sv in the wet, HELP
Quote:
Are you sure the plug gets wet or just assume it cos it's running rough? |
Re: can use my sv in the wet, HELP
tried most of those and still gettin wet, the water id gettin in to the front cilinder and givin me loads of grieff :(
|
Re: can use my sv in the wet, HELP
Quote:
|
Re: can use my sv in the wet, HELP
When you've refitted the plug cap on the front plug have you made sure that the rubber grommet is sat down properly in the grove, if its not fitted properly it'll let the wet back in.
|
All times are GMT. The time now is 06:32 PM. |
Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.