offset woodruff key install, puller tool required

i am about to install an ignition advance key, im reading through the instalation instructions, and i need a rotor pullet tool which is basically an M20 x 1.5mm bolt. ive talked with our purchasign department at work, who have tried to get hold of a bolt for me, but its quite a rare size, M20 are normally 2.5mm pitch thread. they are all special order and cost a BOM, plus there is a minimum order quantity.

does any one have a bolt of this dimension or the actual suzuki special tool (
Suzuki p/n 09930-304450) which i could buy or borrow?

cheers

Adam

[yorkie_chris]

Is there space to get a normal puller in there? Can't remember from last time I had mine in bits.

i think there most likely is enougth space, its just finding a puller tool with the right thread, and ive just spent alot of money on parts, im startign to run a little low now! lol

[yorkie_chris]

I mean a 3 legged puller, could be worth a try, most mechanics have a selection

PM northwind, he has one that was doing he rounds i think, if not he was in posession of one doing the rounds... or someone had one doing the rounds...

either way, there is one around here somewhere.

[Richie]

I've got one also, But I bought mine from a Fastners shop, for only £3.50

I've got also a bolt laying around I not using anymore, but it will cost you more to send it to you than buying a new one.

Originally Posted by yorkie_chris

I mean a 3 legged puller, could be worth a try, most mechanics have a selection

no room and not good idea to use it.

ok, thank you everyone, i cant seem to find one on ebay, can anyone point me in the right direction or send theirs and give me the bill for the postage?

cheers

fyi.I have tested various degree changes,from 1-8 degree in each direction on stock bikes and found no difference worth mentioning.all test done on same day on same dyno.
all runs were within 1hp.