K3 no FI code displaying

Hi,

I'm building a 650k3 up from spares for track use. I've got pretty much everything now, but after connecting all the core loom components/connectors i get the usual CHEC appear on the clocks. I've bridged the connector to it force into dealer mode as per in this link http://forum.svrider.com/showthread.php?t=73604 but no error codes appear, only the CHEC displays. This obivously makes life a bit hard trying to finish things off. When I disconnect the ECU the same thing happens so it's as if the ECU isn't being recognised. However, i connected the ECU from my raod bike and no difference?

Anyone any ideas??? many thanks! Mark

Check the usual "idiot" switches.

If you've only wired in critical loom components for racing, you could even be missing the necessary switches.

Clutch/Sidestand (sidestand switch only really applies if the bike is in gear).

Dodgy kill switch connection?

go round shorting out 1 switch at a time if your going to do it and trying it. No cables caught up anywhere?

Drama over, sidestand switch!! ...oldest one in the book!... tut tut... thanks for the replies, supprisingly it's clear of all FI errors!!

[flymo]

cool, always wondered why the only errors that dont have a code are the ones that always catch us out....

i know, that's what had me wondering...hence the post... i'd like to say i had a defence against the side stand switch embarrassment, but errr, i don't!!!