i have a problem...

after fitting my tail tidy (bought from redbeeproducts off ebay-dont go there)

im now left with this.....



one great big gap... godd innit?

any suggestions on what i could do? or praps an undertray that would fit and needs no cutting?

quick. i feel like crying!

[Rich]

This is the reason why i didn't get a tail tidy and went for the undertray. Why the hell do they make them with the gaps? Surely its just as easy to make them properly than not .. If your only worried about water getting in there you could always use clear silicon to fill the gap!! Apart from that, i suppose you could coverer from the inside with some black plastic or something glued/taped in place!!

Wonder what others have done, is there actually one they make that fits properly??

[Stu]

I can't see any gap in the picture, but you could use a roll of draught excluder if the gap is not too big.

im not too sure whats wrong?

is it that the plate is lower than you wanted?

get a new plate & drill it lower down .perhaps

[Rich]

I hope this helps you all out,, sorry stoppy jumping in

cant see the gap....

because the shovel has been removed, the undertay has nothing to fit into. leaving a gap revealing the screws that attatch the tailtidy to the framework underneath.

was thinking of gaffa taping it up till i can think of something to do to it

Originally Posted by hovis

im not too sure whats wrong?

is it that the plate is lower than you wanted?

get a new plate & drill it lower down .perhaps

nothing to do with the number plate. im going to get a smaller one eventually to raise it up between the indy ut the gap is still there

sorry, i still cant see the problem

can u not get an undertray and then fit the tail tidy to it or dont you wish to do that?