Bar raiser for Curvy?

first of all hiya everyone this is my first post,this site is mint this isnt by any means my first bike but its my first nippy v twin,i'm back after 6 years and my hands are killing me,as ive got a touch of white finger,so i'm wondering if i can get my bars lifted a wee bit,its a 1999 SV650 S thanks in advance for any help or advise
atb
dave

the cheapest way is to get your weight off the bars, i found stompgrip pads meant i could grip the tank more with the knees and not put so much on the bars...

there's also heli bars but they're expensive

or fitting a naked top yoke with flat bars, this is what i eventually did, but it's dependant on getting a top yoke for a good price HTH

Originally Posted by Razor

the cheapest way is to get your weight off the bars, i found stompgrip pads meant i could grip the tank more with the knees and not put so much on the bars...

there's also heli bars but they're expensive

or fitting a naked top yoke with flat bars, this is what i eventually did, but it's dependant on getting a top yoke for a good price HTH

thanks for that razor i think i'll go for the top yoke and bars that sounds the easiest way round it,
atb
dave

I converted my K2 to take renthal bars. I purchased some handlebar mounts from ebay for £15. I then drilled holes in the top yoke so as to fit the mounts. I then had to change the clutch cable for a longer one.I used one from an R6 and soldered a new nipple on to the end. I then had to replace the brake hose for a longer one.I had to cut some of the screen with a dremel tool as the new bars were hitting it. I am happy with the end result and dont get wrist or neck ache anymore. I decided not to change the top yoke as I understand that the Leg mount holes do not quite line up with the bottom yoke. I think they are about 1mm out of line. Best to check before you change the top yoke. Hope this helps a little.
Ian