Cam chain tensioner bolt adjuster thingy me bob

Hello all,

Can someone advise me where the rear cam chain adjuster bolt is please, im planning on getting me spanners out as its ticking.

A photo would be great

Thanks very much

Dan

At the top of the tensioner

http://i176.photobucket.com/albums/w...d/427_2703.jpg

Sorry mate, no idea where that is either

pic posted on it-u got a manual?

Ive got a pdf one which i downloaded.

I take it i just remove that bolt (looks like an 8mm) and put my flat head screwdriver down the hole to "free off" the tensioner??

yep-just turn it until it won't go any further and hopefully you'll hear it shoot back out-if not your tensioners pumped
husky

Im gonna have a go at this because its rattling. I have had em both replaced about 300 miles ago so they should be good.

[jambo]

It's a 10m bolt, and it's a bit awkward to get to, way over on the back right hand side of the rear cylinder, obscured by the frame. You'll need a thin screwdriver

theres a guide on the main page of the site in FAQ and how too's. very good. i did it the other day, and i found it wasnt the chain tensioners it was the slipper plate, same thing the bloke had who wrote the guide.

[northwind]

Basically you stick your arm up your bike's a*** It's on the back of the engine, on the right hand side, just beside the rear exhaust header. Kind of awkard location, I always take the right hand side controls off as it only takes a minute and makes things less annoying.