Justi fitted a standard exhaust. Pipe sealed with silicone. How long before I start motor?

[TEC]

Originally Posted by teriyakimonkey

.. Says on care sheet it goes up to 140 degrees ....

Is that C or F If the later then thats probably a whole lot cooler than your exhaust will get

That'll be centigrade.

[TEC]

Originally Posted by teriyakimonkey

That'll be centigrade.

In that case ....

Originally Posted by Dangerous Dave

...Proper gasket silicone is the stuff to use.

Sounds like thats what you've got So should be ok

Originally Posted by teriyakimonkey

I used bathroom type silicone. Meant to take 24 hours but it's such a thin layer in there.

Bathroom silicone! Are you serious? Thats gonna toast big style, why didnt you get exhaust sealant????

Because Mr Durbs I was told either on here or another forum or in person (I can't remember which) that normal bathroom sealant is fine for sealing a sleeve.

Well I'm not going to change it now so I'll report back next week after I've given it a good run. If it all shoots out then so be it. If it doesn't then so be that.