Whoops binned it - help with repairs required

Originally Posted by shop_addict

I'd broken the plastic housing and bulb, so I'm not sure whether it was just those bits that were replaced, or the whole thing.

Sorry I can't be of more help.

Jo -> not always dopey, honestly

No problem, I've got the rubber bit so it's not really an issue regarding repairs, more I was wondering if it was worth specifying not to include that bit, if it meant a couple of quid off.

[fizzwheel]

Cant really help with repair advice, but sorry to hear about your bike, hope you get it sorted out OK

Originally Posted by Ceri JC

You all mention removing the rubber bung already in there. Do you mean the one at the outer edge of the bar, or is there one wedged deep inside that the original screw goes through?

There's one wedged deep inside, trust me, been there done that. My replacement bar end had the wrong length bolt too, can you re-use your original bolt or was it bent?

Dean

Thanks for the help folks. Bar ends are sorted now and aside from the indicator (going to order it today), she's ready to be back on the road.

Having the bike in bits has given me a good opportunity to clean in those hard to reach places and even autosol some of the rust off the frame. Many thanks for your help and encouragement everyone, it's much appreciated.

Bugger, very similar thing happened to me last year only my disc got bent. I still haven't replace the bar ends

I didn't realise indicators were so expensive.

Hey Ceri,

Sorry I missed this, Glad you're ok, hope the bike is sorted and fine!!!

See you over on Sv1000.zyns soon!

Tracy