Removing number plate hanger.

Originally Posted by andyaikido

How much did you pay for it? I paid £50 and I don't think you get very much for your money, number plate light's rubbish aswell. Bit of a disapointment as I like their crash protection gear.

i paid £30 delivered off ebay, your right they arnt very good the paint was starting to flake on mine as i was tightening up the bolts and the plate light is near useless.
still they look good fitted, lots better than the old snow shovel.

Well I managed to remove and fit my tail tidy with a few problems. First of all it's just a huge pain in the ass to do it. Secondly some of the bolts for the original number plate holder are very hard to get to. But I did it. Then i realised the indicators I bought did not have the special connectors needed so I just cut the originals and spliced them together. Bit of insulation tape and robert's your mother's brother! So I got teh tail tidy in and then placed the fairing back on. Now I get two little bits of plastic either side at the bottom of the rear light that I can't fasten back in with the little black fasteners. You can barely see it so I guess it's ok. But then I realised my number plate is too big to fit teh bracket.........AAAAAAAAAAARGH!

Well I managed to force it on but it covers about 2mm of each indicator. Still, it does look much better. Will post pics soon.

Originally Posted by sv_dan

Well I managed to force it on but it covers about 2mm of each indicator.

They all (hamicad) do that sir, mine and a mates were the same.