Head bearing, dust seal

Where can i get one from, mine has split (part No:51643-33E00)

i dont want to go to a dealer if i dont have to

webmoto dont have them and ebay don't ether

Thanks

£11 from Robinsons foundry, not too much?

[Spanner Man]

Good morning.


Suzuki headraces are a little rude in their pricing. Honda use the same bearing on most models, & they're somewhat cheaper.
If you were to go to a Honda dealer & order the bottom seal for say a CB500, or a VFR750 of 1990's vintage, you will find it's the same seal, & a little cheaper. It's around £6 methinks.

The top bearings on Hondas have a 1mm bigger bore, therefore one cannot use Honda bearings or the seals. However top seals rarely wear, & one doesn't muller them removing the bearing from the stem, unlike the lower bearing/seal.


Cheers.

Hi ordered one from Robinson's foundry, had to swallow it cost me £14 inc P&P

and spanner man, the seal had dried out and had split before i removed it the bottom curtain like bit is where it was split, could have reused it but would rather my nice shiny new bearings didn't get full of junk :P