Motrax Fla**** unit

Anybody know where i wire this thing in? There is no instructions with it.

[M.C.]

don't think they work on suzuki's mate

what is it ?
what it do ?

i fitted a similar l.e.d relay unit to my curvey now removed but it worked fine when it was on there.

Basically you need to make sure you have a 2 wire version and not the 3 wire version, then remove the front riders seat.

Under the seat is the relay and compartment above the battery now the smaller relay on the right hand side hold the flasher relay unit but also has the side stand relay built in with it.

You need to get a small screwdriver remove the 2 wires which are for the flasher relay (need to look at wiring diagram as i've forgotten) pull these out from the bottom replace the relay so the side stand part stil works then you wire your motrax relay up to the 2 removed wires which then makes that your new flasher unit and you can drill 2 holes and cable tire it in place.

All sounds a bit confusing but its simple really just need to look at a wiring diagram to check which wires to remove and need be the old relay can always be reconnceted anytime as long as you dont cut the wires.

hope this is some help, if you had been more local could have done it for you.

Originally Posted by Phoenix

Basically you need to make sure you have a 2 wire version and not the 3 wire version.

I do have the 2 wire type (didnt know there wass a three wire type)

Cheers Phoenix, sounds fairly simple, ill be having a crack at it later.

Some other bikes have the three wire type but since you have the 2 wire one should have no problems.

Hope you get it sorted

Leslie