Stubbie'd my endcan.

[Wideboy]

yorkie don't suppose you could PM the length of yours (ooh eerr) as i want to be a copy cat plz plz plz

Wish i still had mine now to show ya's I can confirm that they are bloody loud!

[yorkie_chris]

Originally Posted by Wideboy

yorkie don't suppose you could PM the length of yours (ooh eerr) as i want to be a copy cat plz plz plz

I'm sure missYC will tell you its about 13"

[Wideboy]

Originally Posted by yorkie_chris

I'm sure missYC will tell you its about 13"

i will make mine smaller ........ oh wait............ damn




cheers matey

I've been thinking of doing this to my micron. As far as I can tell, I don't have a removable baffle, or if I do, it was long gone by the time I got the bike.. So I'm a bit worried about cutting off a few inches and having it too loud and not being able to do anything about it

[Lissa]

Originally Posted by yorkie_chris

I'm sure missYC will tell you its about 13"

Just measured ours...................9"

I did this to my sv1000 cans!! isnt stainless a bitch to drill like you say getting the ends back in and the straps around the end with the new stainless rivets in is a pain, it sounds evil with the baffles out

Just gone and had a look at mine.. here's a couple of pics. To me (and I don't know a thing ) it looks like a bit too much work to cut this down, or is it doable?

It screws in from the end, not on the sides of the can itself.








What say you?

Originally Posted by yorkie_chris

I'm sure missYC will tell you its about 13"

heehee that made me chuckle

[Lissa]

Originally Posted by Sean_C

Just gone and had a look at mine.. here's a couple of pics. To me (and I don't know a thing ) it looks like a bit too much work to cut this down, or is it doable?

It screws in from the end, not on the sides of the can itself.








What say you?

That looks like it would be more difficult, purely because of the way the end fits.