Stainless Steel Micron Race headers/downpipe for Pointys

xxbadgerxx will be owed a big thanks from me. Ebay has saved me £££'s and i even bagged some M8 stainless for free today

Originally Posted by yorkie_chris

Best full system for the curvy is leo vince

On a vaguely standard engine yes.

Originally Posted by Dangerous Dave

On a vaguely standard engine yes.

I've got pointy cams so looking to hit 72bhp. Will be going for a Hindle or M4 system I think. But if I could have got a Micron on for a ton that would have been acceptable!

J

Originally Posted by weecorey

Anyone know the diameter of these?

Which diameter measurement are you after matey?

Originally Posted by lawson17

Which diameter measurement are you after matey?

Diameter of the down pipes and I supose the link pipe. I have a hi level Leovince hare and was going to buy the rest of the system but those microns are cheap if they would fit my can. I know the M4/leovince headers are bigger than standard and wanted to know if the microns are the same.

If you can wait until tomorrow I'll take down all the measurements and post them here.

It's a bit dark out at the moment you see...

[maviczap]

Originally Posted by lawson17

If you can wait until tomorrow I'll take down all the measurements and post them here.

It's a bit dark out at the moment you see...

I'll save you the trouble. Downpipe/header diameter is 38mm and link pipe diameter is 52mm

Mines got a Scorpion end can which fits fine on the link pipe

Originally Posted by weecorey

but those microns are cheap

They are a budget system, not a performance system.

Originally Posted by maviczap

link pipe diameter is 52mm

All the budget UK exhaust will fit onto the Micron link pipe.

The headers (out of the cylinder heads) are indeed 38mm OD.

The outlet where you slip the link pipe onto is indeed 52mmOD.

However, the high level link pipe supplied with this is 57mm OD.

I had to modify my blueflame by cutting off the the original fitting, and Tig-ing on a section of 57mm ID stainless tube.

But I would imagine if you only want to use the headers and your own link pipe, other budget systems will fit?

Originally Posted by lawson17

However, the high level link pipe supplied with this is 57mm OD.

That is the diameter of the link pipe at the bottom (under the footrest), yes?